Post by Deleted on Jan 19, 2015 15:11:49 GMT -6
This was a major glue bomb when i got it. The only way i could save it was to make a gasser out of it because a lot of the messed up stuff got cut out.
I used a blown Ford 427 SOHC, used fingernail polish to paint the body, used solder to make the roll bar, took a full face motorcycle helmet and modified to make an old school helmet. I used sheet styrene to make the cover over the interior and cut off the deformed top to make a convert. The push bar is scratch built from styrene square stock, used styrene to make the parachute mount, made the headers from solder and used sticky letters for the name. I used aluminum tube for the steering wheel shaft so it pulls out.
I used a blown Ford 427 SOHC, used fingernail polish to paint the body, used solder to make the roll bar, took a full face motorcycle helmet and modified to make an old school helmet. I used sheet styrene to make the cover over the interior and cut off the deformed top to make a convert. The push bar is scratch built from styrene square stock, used styrene to make the parachute mount, made the headers from solder and used sticky letters for the name. I used aluminum tube for the steering wheel shaft so it pulls out.
